The depth spectrums of constacyclic codes over finite chain rings

In light of the generator polynomials of constacyclic codes over finite chain rings, the depth spectrum of constacyclic codes can be determined if (n,p)=1$(n,p)=1$.     

Commuting Toeplitz operators on the hardy space of the polydisk

In this paper, we show that two Toeplitz operators T_f and T_g on the Hardy space of the polydisk can commute if and only if the Berezin transform of the commutator [T_f, T_g] is n-harmonic.     

双模随机晶场对纳米管上Blume-Capel模型磁化强度和相变的影响

近年来, 磁性纳米管的物理性质和相关应用得到了人们的广泛关注. 利用有效场理论研究了纳米管上双模随机晶场中Blume-Capel模型的磁化强度和相变性质, 得到了系统的磁化强度与温度和随机晶场的关系及其相图. 结果表明: 系统在稀释晶场、交错晶场和同向晶场中会表现出不同的磁学性质和相变行为; 稀释晶场和交错晶场会抑制系统的磁化强度, 导致其基态饱和值小于1, 而同向晶场则不会; 随着随机晶场参量的变化, 系统存在多个相变温度, 并呈现出三临界现象和重入现象.     

奥氏体不锈钢深冷低温冲击试验方法研究

以液氦作为冷源,结合G-M低温制冷机,实现-196~-269℃深冷温度环境,探索深冷低温冲击试验方法。结果表明,试样从低温环境中取出后置于大气环境中,温度出现快速回升。对于不同试验低温,可采用不同方法进行试验。试验温度T=4.2K时,可采用制冷机预冷+液氦持续喷淋的方法进行降温。试验温度10≤T77K时,可采用玻璃容器填充气凝胶粉体对试样进行绝热保温处理;或根据试验温度以及回温测试结果,以一定的过冷温度补偿值保证试验温度。过冷温度补偿方法可满足常规冲击试验的要求,但需要相对较大的过冷温度补偿值;玻璃容器填充粉体包裹试样,可减缓试样温度回升,但对材料冲击吸收能量有一定影响,可用多试样冲击试验并进行修正以反映材料冲击韧性水平。     

520nm泵浦780nm+1560nm双共振光学参量振荡器

我们在实验中演示了520nm单频绿光泵浦的基于周期极化磷酸钛氧钾(PPKTP)晶体的780nm+1560nm双共振光参量振荡器,高效制备780nm+1 560nm连续可调谐双色下转换光场。该参量振荡器可输出93.3 mW的1 560nm单频激光和44.6mW的780nm单频激光。通过改变PPKTP晶体的温度所得到的波长粗调范围为:信号光1 529.81nm~1 573.83nm(~44nm),闲置光788.26nm~777.20nm(~11nm);通过连续调谐520nm泵浦激光频率初步得到的闲置光在780.24nm(铷原子D2线)处频率连续调谐范围约1.6GHz。     

Study on LiFe<Subscript>1 − <Emphasis Type="Italic">x</Emphasis></Subscript>Sm<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript>PO<Subscript>4</Subscript>/C used as cathode materials for lithium-ion batteries with low Sm component

LiFe_1???x Sm _x PO₄/C cathode materials were synthesized though a facile hydrothermal method. Compared with high-temperature solid-phase sintering, the method can allow for the fabrication of low Sm content (2 %), a scarce and expensive rare earth element, while the presence of an optimized carbon coating with large amount of sp²-type carbon sharply increases the material’s electrochemical performance. The high-rate dischargeability at 5 C, as well as the exchange current density, can be increased by 21 and 86 %, respectively, which were attributed to the fine size and the large cell parameter a/c as much. It should be pointed out that the a/c value will be increased for the LiFePO₄ Sm-doped papered by both of the two methods, while the mechanism is different: The value c is increased for the front and the value a is decreased for the latter, respectively.     

DDA与FEM耦合法在分缝重力坝非线性分析中的应用

混凝土重力坝一般设有数条纵缝。纵缝使坝体的连续性遭到破坏，一般的有限单元法很难处理这样的不连续变形问题。本文首先阐述了DDA(Discontinuous Deformation Analysis)与FEM(Finite Element Method)耦合算法的原理，然后采用作者自行研制的DDA与FEM耦合法程序对一实际重力坝进行了详细的计算分析。重点讨论了纵缝的不同设置形式和缝宽大小对坝体变形和应力分布、坝底面接触应力分布以及坝基面应力分布的影响，为工程设计提供依据。